7'10" Jive Space Elevator surfgear the rocker is flat on

the rocker is flat on the deck but offers some curve on the bottom

Origin: Guatemala + Colombia

but tends to excel in a wave with a longer length of ride

The bottom contour of the board consists of a slight roll in the nose that move to a subtle single concave that run the remainder of the board

The bottom contour starts with a slight single concave in the nose that runs into a triplane hull that runs into 3 tight channels that run the middle of the board out the tail

7'10" Jive Space Elevator surfgear the rocker is flat on7'10" x 21 3 4" x 3" Jacob Ells is a Santa Barbara based shaper who is always looking to push the boundaries of alternative boards. The Space Elevator model was made to trim with long parallel foiled rails, pulled in nose, and rounded tail. The rocker of the board is low allowing for high down the line speed. The bottom contour is quite interesting starting flat in the nose and quickly turning into a tri plane hull with a deep single concave that runs